Arlo camera is the unanimous choice of users worldwide. There are plenty of reasons why peoples from all across the world prefer to use this camera when it comes to securing their premises. With advanced features like wire-free operation, night vision, HD recording, motion alert, weather resistance, etc there is nothing much a user can wish for. Even though rare but at times there can be certain issues which can bar the camera from recording the footage. One such issue that the users have reported worldwide is “Unable to Login Arlo Account”. The issue is a bit cumbersome for people with no knowledge of the internal functioning of the device. In the article that follows, we have given some useful troubleshooting tips to resolve the issue that the user face while performing Arlo Login My Accountprocess. Every aspect is covered in detail to ensure an enhanced device experience.
Reasons for Unable to Login into Arlo Account
Before getting into the troubleshooting steps, it is crucial to know the reasons behind the error. Let’s have a look at some of the major reasons behind the Unable to Login into my Arlo Account issue.
Check your username and password correctly.
It could happen due to poor internet connectivity.
Poor or fluctuating power supply.
Your browser session might be corrupted.
Due to the configuration.
It could happen due to the improper installation of the battery in the battery compartment of the Arlo camera.
Make sure that internet cache and cookies are cleared.
If none of the above-mentioned points is the reason behind the issue, then try configuring the Netgear Arlo camera again. Configuring it again will not consume much time as it could be done within 10-15 minutes.
Configure Netgear Arlo Camera
By configuring your Netgear Arlo Camera in a proper way, you may not face this issue again. Have a note on some of the below-listed points and configure your Netgear Arlo Camera. For help regarding login Arlo account issue, connect with the service team.
#1. Install Base Station
Use an Ethernet cable and connect it to the base station.
Connect the AC adaptor to the base station.
Now, you need to plug the AC adapter into the base station.
Check the backside of the base station and on-off the button once.
Now, the power LED and the internet LED will blink in green color.
Register for an Arlo Account and Log in Again
Open any web browser and enter arlo.com/ log into Arlo the address bar.
Click or tap the New System Setup.
Fill in the required fields and continue to the next.
Select your base station’s serial number from the drop-down menu.
Tap the ‘Continue’ button.
Sync Arlo Camera
Get your camera close up to one to three feet (30cm–100cm) of the base station.
Press and release the sync button.
Wait until the Sync Status LED shows a green light.
Now, press and release the sync button on the camera.
A blue LED will blink confirm the successful sync.
Position your Camera
The positioning of Arlo camera is very important. Make sure that you have placed your Arlo camera a maximum of 300 feet (90 meters) from the base station.